升降貨梯冷卻器安裝方法

文章出處：www.guangjiasu.com 責任編輯：admin 人氣：6313 發表時間：2016-04-05 13:06:32

升降貨梯中的冷卻器一般應安放在回油管或低壓管路上，這樣可防止冷卻器承受高壓且冷卻效果也較好。如溢流閥的出口，系統的主回流路上或單獨的冷卻系統。
Lift manufacturers introduced lift the cooler should normally be placed in the return pipe or low pressure pipeline, which prevents cooler withstand high pressure and the cooling effect is better. Such as the main export reflux relief road system or separate cooling system.

升降貨梯冷卻器所造成的壓力損失一般約為0.0lMPa，液壓系統的加熱一般常采用結構簡單、能按需要自動調節最高和最低溫度的電加熱器。加熱器安裝時用法蘭盤水平安裝在油箱側壁上，發熱部分全部浸在油液內。加熱器應安裝在箱內油液流動處，以有利于熱量的交換。由于油液是熱的不良導體，單個加熱器的功率容量不能太大，以免其周圍油液過度受熱后發生變質現象。
Manufacturers remind you lift the pressure loss caused by the cooler is generally about 0.0lMPa, heating of the hydraulic system is generally often used a simple structure, can be automatically adjusted according to the maximum and minimum temperatures of the electric heater. Heater installation with horizontal flange on the tank side wall portion of all heat soaked in oil. Heater should be installed in the box at the oil flow to facilitate heat exchange. Because oil is a poor conductor of heat, power capacity of a single heater is not too large, in order to avoid deterioration phenomenon occurred after the oil around excessive heat.

下一篇：導軌升降機吊籠下滑的檢查方法上一篇：套缸升降機體統內操作要點

此文關鍵字：升降貨梯